To draw a rectangle or a square

• Click the Rectangle tools button, and click a rectangle tool. To draw a Do the following

2-point rectangle Click the 2-point rectangle tool □. Point to where you want the rectangle to start, drag diagonally until the rectangle is the size you want, and release the mouse button.

To draw a

Do the following

3-point rectangle

Click the 3-point rectangle tool n. Point to where you want the rectangle to start, and drag to draw the angle and width. Move the pointer to where you want the third point, and click.

Square

Choose one of the above rectangle tools, and hold down the constrain key while you draw.

You can draw a rectangle from its center outward by holding down Shift as you drag. You can also draw a square from its center outward by holding down Shift + Ctrl as you drag.

You can draw a rectangle that covers the drawing page by double-clicking the 2-point rectangle tool.

To apply the same roundness to all corners, click the Geometric properties button S3 on the property bar, and enable the Round corners together check box.

To set default corner roundness, click Tools > Options, double-click Toolbox in the list of categories, click Rectangle tool, and move the slider or enter a number.

Was this article helpful?

0 0

Post a comment