To skew an object

1 Select an object.

2 Click Arrange > Transformations > Skew.

3 In the Transformations docker, enable the Horizontal skew option £7 or Vertical skew option and type a value in the Angle box.

4 Enable the Origin point about which to skew the object.

If you want to leave the original object unchanged and apply the transformation to copies that are created, type a number in the Copies box.

You can also mirror a selected object by holding down Ctrl and dragging a selection handle to the opposite side of the object.

If you move the skew anchor point, you can reset it to the center again.

You can also skew an object interactively by dragging one of its skew handles.

Was this article helpful?

0 0

Post a comment