Applying fills to extruded and beveled surfaces

You can apply the control object's fill to the extruded surfaces. You can drape the control object's fill so that it covers the entire extrusion seamlessly. You can also apply the extrusion's fill or a different fill to beveled surfaces.

Clockwise from top-left: using the object's fill, draping the fill, applying a different fill or the extrusion's fill to a bevel.

Clockwise from top-left: using the object's fill, draping the fill, applying a different fill or the extrusion's fill to a bevel.

Extrusion Corel Draw

To apply a control object's fill to extruded surfaces

K I Select the extrusion with the Pick tool. © 2 Click the Color button on the Property Bar. 0 3 Enable the Use Object Fill button.

The button is enabled when it appears pressed.

To drape the fill

1 Follow all of the steps from the previous procedure.

2 Enable the Draped Fills check box.

To apply an extrusion's fill to beveled surfaces

1 Follow all of the steps from the "To apply a control object's fill to extruded surfaces" procedure.

W 1 Enable the Use Extrude Fill For Bevel button.

The button is enabled when it appears pressed.

To apply a different fill to beveled surfaces

1 Follow all of the steps from the "To apply a control object's fill to extruded surfaces" procedure.

2 Disable the Use Extrude Fill For Bevel button. The button is disabled when it appears raised.

3 Open the Bevel Color picker, and click a color.

Was this article helpful?

0 0

Post a comment