To enable media pooling

1 On the Stroke Designer page of the Brush Creator, click Spacing.

2 Enable the Continuous Time Deposition check box.

When the Continuous Time Deposition check box is disabled, you must move the brush (even just slightly) to cause media to be deposited.

Because there are no restrictions on bearing (stylus direction) in Corel Painter, you can create full 360° strokes with noncomputed brushes by completing an arc without interruption. Computed brushes use bearing, with the exception of those that use the Rendered dab type, so you cannot use them to create 360° strokes.

Was this article helpful?

0 0

Post a comment